| 1. | The method of determining the oil - gas - water contact . the gas - water contact
油气水界面确定方法.气水界面 |
| 2. | The application of material of pressing hg in confirming oil - water contact
压汞资料在确定油水界面中的应用 |
| 3. | The method of determining the oil - gas - water contact . the oil - gas and oil - water contact
油气水界面确定方法.油气油水界面 |
| 4. | Test method for corona - treated polymer films using water contact angle measurements
利用水触角测量仪进行电晕处理聚合物薄膜的试验方法 |
| 5. | Rreduced wiring time ip67 iec60529 leakproof seal water contact sealed envelope can be drainage
Ip67 iec60529防漏水密封触点密封，外壳可排水 |
| 6. | Standard test method for corona - treated polymer films using water contact angle measurements
用水触点角度测量法测定电晕处理聚合物薄膜的标准试验方法 |
| 7. | Water contact angle measurement of the control and the modified plla membranes indicated that the hydrophilicity of the membrane was improved obviously after the grafting modification
Atr - ir和xps测试结果证明了接枝聚合的发生。接触角测试结果表明改性后plla膜表面的亲水性明显提高。 |
| 8. | The character of the reservoir is typical of low permeability , high stress - sensitive , high capillary pressure value , steep capillary pressure curve , high critical water saturation , blur gas - water contact
物性特徵表现为渗透率低且对应力敏感，毛管压力高，毛管压力曲线陡峭，临界水饱和度高，气水界面模糊。 |
| 9. | Effected by many factors during huff and puff , the reservoir of edge water invasion and complex small fault block , the producing wells which are located in the neighborhood of the fault trace and oil - water contact , are quite difficult for development
摘要由于在蒸汽吞吐开发过程中要受到多种因素的影响，而且生产井处于断层和油水边界附近，所以层间水复杂小断块稠油油藏的开发难度较大。 |
| 10. | Ir , sem - edx , and water contact angle measurements on polysilane and polyacrylate film obtained by double operations and single operation showed that the influence of weight ratio of polymers , the molecular of pmma on film structure was great . the film translucence dropping while the ratio of pmma / pmts grew and the compatible reducing while the molecular of pmma increased
通过测定所配制的系列浓度聚合物甲苯溶液、 thf溶液的表面张力发现：有机硅聚合物溶液的表面张力值在有机硅聚合物浓度低于30时变化不明显；而甲基丙烯酸酯聚合物溶液表面张力值随甲基丙烯酸酯聚合物浓度的变化比有机硅聚合物溶液明显。 |
